Operation - Omron G9SP Series Reference Manual

Function Blocks
Name Notation on
Function List
Redundant Generic Two-
Input input Monitor-
ing
Single Beam Single Beam
Safety Sensor Safety Sensor
Monitoring
Non-Contact Non-Contact
Door Switch Door Switch
Monitoring
Safety Mat Safety Mat
Monitoring
2-1-4 Reset and Restart Function Blocks
Name Notation on
Function List
Reset Reset
Restart Restart
2-1-5 Connector Function Blocks
Name Notation on
Function List
Multi Connector Multi Connec-
tor
Routing Routing
10
Icon
Monitors for discrepancies in two input signals. Not supported.
Monitors the input signal of an OMRON E3ZS/
E3FS Single-beam Safety Sensor.
The Non-Contact Door Switch function block
monitors the status of an OMRON D40A or
D40Z Non-contact Door Switch.
Monitors the status of an OMRON UM Safety
Mat.
Icon
Outputs ON if the reset signal is correctly input
while the input condition is ON. This function
block can be used to prevent equipment from
starting automatically.
Performs the same operation as a Reset func-
tion block. The icon is different.
Refer to 3-6-1 Reset for a description of func-
tions and setting parameters.
Icon
Outputs the status of the input signals.
Distributes an input signal to multiple signals.
Details
Details
Details
Section 2-1
Support by Page
NE1A-series
Controllers
74
Not supported. 74
Not supported. 74
Not supported. 75
Support by Page
NE1A-series
Controllers
All unit versions 76
All unit versions 78
Support by Page
NE1A-series
Controllers
NE1A-series Con- 79
trollers with unit
version 1.0 or
later
All unit versions 80