Chicago Electric 98839 Set Up, Operating, And Servicing Instructions page 14

If the Engine will be run in temperatures below 32 degrees Fahrenheit, use SAE
5W-30 weight oil. (See Figure D, prior page.)
3. To do so, unscrew and remove the Oil Dipstick (65A). Pour engine oil into the oil
fill hole until the level of oil is even with the bottom edge of the oil fill hole (if you
cannot see the oil through the oil fill hole, then the oil is too low and more oil must
be added). (See Figure D.)
4. Make sure to screw the Oil Dipstick (65A) firmly back into its Dipstick Hole.
(See Figure D.)
To Fill The Fuel Tank:
1. Prior to first using the Generator, the Fuel Tank (31)
unleaded gasoline. (See Figure D.)
2. To do so, remove the Fuel Tank Cap (34) and fill the Fuel Tank (31) with unleaded
gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Fuel Gauge (35)
for the amount of unleaded gasoline. When necessary, refill the Fuel Tank.
(See Figure D.)
NOTE: Periodically, make sure to check the Fuel Filter (32) for excessive dirt and debris.
If necessary, remove the Fuel Filter and clean with compressed air.
(See Figure D.)
ThiS uNiT cAN POWER ThE FOLLOWiNG iTEMS
NOTE: Wattages listed above are estimates. Check nameplate wattages on all loads
before connecting to Generator.
SKU 98839 For technical questions, please call 1-800-444-3353.
iTEM
1 HP Air Compressor
Belt Sander
Pressure Washer
Refrigerator/Freezer
1/2 HP Sump Pump
1/2 HP Well Pump
Miter Saw
1-1/2 HP Capacitor Start &
Run Motor
Central AC-32, 000 BTU
10" Table Saw
must be filled with high octane
RuNNiNG START-uP
WATTS WATTS
1600 4500
1200 2400
1200 3600
700 2200
1050 2150
1000 2100
1650 3000
1400 3100
5000 6500
1800 4500
REV 09h
Page 14