Chicago Electric 98839 Set Up, Operating, And Servicing Instructions page 13

8. 12 volt Dc Fuse (8):
erator from overloading. The Generator is equipped with the following size and type
of Fuse: F10A250v. Should a 12 VDC output exceed the fuse's rating, always
check to see if the Fuse has "blown" (a melted filament within the Fuse). If neces-
sary, unplug all electrical loads from the Generator, replace with a new Fuse, and
reattach a reduced load to the generator. (See Figure c.)
9. Power-On Light (10):
(See Figure c.)
To Add Engine Oil:
1. cAuTiON!
crankcase prior to its first use. Before each use, check the oil level. Never run the
Engine with low or no engine oil. Running the engine with low or no oil will perma-
nently damage the Engine.
FuEL GAuGE
(35)
FuEL TANK
(31)
2. The Engine MuST be filled with a high quality grade engine oil. If the Engine will
be run in temperatures above 32 degrees Fahrenheit, use SAE 10W-30 weight oil.
SKU 98839 For technical questions, please call 1-800-444-3353.
The 12 Volt DC Outlet has one Fuse (8) to protect the Gen-
Indicates voltage is being provided by the Generator.
PRE-START iNSTRucTiONS
Your warranty is voided if you do not put engine oil in the Engine's
OiL DiPSTicK
(65A)
FuEL FiLTER
(32)
FuEL TANK cAP
(34)
ThiS GENERATOR
hAS AN AuTO-
ShuTDOWN OiL
SENSOR. iF
ENGiNE STOPS OR
WiLL NOT START,
chEcK OiL LEvEL.
FiGuRE D
Page 13