Upgrading Your Printer Dock Firmware - Kodak EasyShare G600 User Manual

Maintenance and firmware upgrade

Upgrading your printer dock firmware

IMPORTANT: To upgrade the firmware, your printer dock must be powered by the AC
adapter (not the printer battery).
From your computer
Connect your printer dock to your computer (see
version of the printer dock firmware (the software that runs on the printer dock) to
your computer. Visit www.kodak.com/go/printerdockdownloads.
From your USB flash drive
1 Transfer the latest version of the printer dock firmware file from your computer to
your USB flash drive System or Service folder.
2 Connect your printer dock to the AC power adapter (see
camera to the printer dock (see
3 Connect the USB flash drive to your printer dock's USB device connector (see
page 28).
The printer dock automatically checks the firmware file version on the flash drive.
4 Press Print,
To exit the firmware upgrade process, use the
select Exit on the camera.
5 Follow your camera's on-screen instructions.
The Red-eye, Transfer, and Print buttons blink until the upgrade is complete. Blinking
stops approximately 5 seconds after the upgrade is complete.
6 Remove the USB flash drive and power your printer dock off, then on again.
40
page
, on your printer dock to begin the firmware upgrade.
page 22). Download the latest
7).
buttons on the printer dock to
www.kodak.com/go/support
page 3), and dock your