Epson EB-4955WU User Manual page 76

List of Functions
Submenu
Auto Setup (Only available when an analog RGB computer signal is
being input.)
Set to On to automatically adjust Tracking, Sync., and
Position to the optimum state when the input signal
changes.
Resolution (Only available when an analog RGB computer signal is
being input.)
Set to Auto to automatically identify the resolution of the
input signal. If images are not projected correctly when set
to Auto, for example if some of the image is missing, set to
Wide for wide screens, or set to Normal for 4:3 or 5:4
screens depending on the connected computer.
Manual allows you to specify the resolution. This is ideal
when connected computer is fixed.
Tracking (Only available when an analog RGB computer signal is
being input.)
You can adjust computer images when vertical stripes
appear in the images.
(Only available when an analog RGB computer signal is
Sync.
being input.)
You can adjust computer images when flickering, fuzziness,
or interference appear in the images.
You can adjust the display position up, down, left, and right
Position
when a part of the image is missing so that the whole image
is projected.
* When projecting passive 3D images using two projectors, set
3D Setup
3D Images to On.
g
Interlace
Progressive
conversion)
Off: Ideal for images with a large amount of movement.
Video: Ideal for general video images.
Film/Auto: This is ideal for movie films, computer graphics,
and animation.
Function
(i) signal is converted to Progressive
Submenu
Noise Reduction
Mosquito NR
Video Range
Input Signal
Video Signal
g
(p). (IP
Aspect
Function
(This cannot be set when Image Processing is set to
Fast.)
Smoothes out the roughness in progressive images. There
are two modes. Select your favorite setting. It is
recommended that this is set to Off when viewing image
sources in which noise is very low, such as for DVDs.
(This cannot be set when Image Processing is set to
Fast.)
When a progressive signal is being input, you can reduce
the wavy noise that occurs in lines between areas with
dramatic changes in colors.
Select the video range for the input signal from the HDMI
port and the DisplayPort. Set to Expanded if you are
concerned about misadjusted black levels or blown out
highlights in the image.
You can select an input signal from the Computer port or
BNC port.
If set to Auto, the input signal is set automatically
according to the connected equipment.
If colors do not appear correctly when set to Auto, select
the appropriate signal according to the connected
equipment.
You can select an input signal from the Video port or S-
Video port. If set to Auto, video signals are recognized
automatically. If interference appears in the image or a
problem occurs such as no image is being projected when
set to Auto, select the appropriate signal according to the
connected equipment.
g
You can set the aspect ratio for projected images.
s "Changing the Aspect Ratio of the Projected Image "
p.45
76