Switch Port Commands - D-Link xStack DES-3500 Series Cli Manual

The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ports
show ports
Each command is listed, in detail, in the following sections.
config ports
Purpose Used to configure the Switch's Ethernet port settings.
Syntax config ports [<portlist | all>] {speed [auto | 10_half | 10_full |100_half | 100_full |
1000_full]} | flow_control [enable | disable] | learning [enable | disable] | state
[enable | disable] | trap [enable | disable] | description <desc 32>}
Description This command allows for the configuration of the Switch's Ethernet ports. Only the ports
listed in the <portlist> will be affected.
all − Configure all ports on the Switch.
Parameters
<portlist> − Specifies a port or range of ports to be configured.
speed – Allows the user to adjust the speed for a port or range of ports. The user has a
choice of the following:
flow_control [enable | disable] – Enable or disable flow control for the specified ports.
learning [enable | disable] − Enables or disables the MAC address learning on the
specified range of ports.
state [enable | disable] − Enables or disables the specified range of ports.
trap [enable | disable] − Enables or disables trap support on the switch.
description <desc 32> - Enter an alphanumeric string of no more than 32 characters to
describe a selected port interface.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure the speed of port 3 to be 10 Mbps, full duplex, with learning and state enabled:
DES-3500:admin#config ports 1-3 speed 10_full learning enable state
enable
Command: config ports 1-3 speed 10_full learning enable state enable
Success.
DES-3500:admin#
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
Parameters
[<portlist | all>] {speed [auto | 10_half | 10_full |100_half | 100_full | 1000_full]} |
flow_control [enable | disable] | learning [enable | disable] | state [enable | disable] | trap
[enable | disable] | description <desc 32>}
[<portlist>] {description}
• auto − Enables auto-negotiation for the specified range of ports.
• [10 | 100 | 1000] − Configures the speed in Mbps for the specified range of
ports. Gigabit ports are statically set to 1000 and cannot be set to slower
speeds.
• [half | full] − Configures the specified range of ports as either full-duplex or half-
duplex.
S
WITCH
24
6
P C
ORT OMMANDS