Commands (Including Guest Vlans) - D-Link xStack DES-3500 Series Cli Manual

The DES-3500 implements the server-side of the IEEE 802.1x Port-based and MAC-based Network Access Control. This
mechanism is intended to allow only authorized users, or other network devices, access to network resources by establishing
criteria for each port on the Switch that a user or network device must meet before allowing that port to forward or receive frames.
Command
enable 802.1x
disable 802.1x
show 802.1x auth_state
show 802.1x auth_configuration
config 802.1x capability ports
config 802.1x auth_parameter
ports
config 802.1x auth_protocol
config 802.1x init
config 802.1x auth_mode
config 802.1x reauth
config radius add
config radius delete
config radius
show radius
create 802.1x guest_vlan
config 802.1x guest_vlan ports
delete 802.1x guest_vlan
show 802.1x guest_vlan
Each command is listed, in detail, in the following sections
enable 802.1x
Purpose
Syntax
Description
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
802.1X C
OMMANDS
Parameters
{ports <portlist>}
{ports <portlist>}
[<portlist> | all] [authenticator | none]
[<portlist> | all] [default | {direction [both | in] | port_control [force_unauth
| auto | force_auth] | quiet_period <sec 0-65535> | tx_period <sec 1-
65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> |
max_req <value 1-10> | reauth_period <sec 1-65535> | enable_reauth
[enable | disable]}]
[radius eap | radius pap]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist> |all]
{mac_address <macaddr>}]
[port_based | mac_based]
{port_based ports [<portlist> | all] | mac_based [ports] [<portlist> | all]
{mac_address <macaddr>}]
<server_index 1-3> <server_ip> key <passwd 32> [default | {auth_port
<udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>}]
<server_index 1-3>
<server_index 1-3> {ipaddress <server_ip> | key <passwd 32>
[auth_port <udp_port_number 1-65535> acct_port <udp_port_number 1-
65535>]}
<vlan_name 32>
[<portlist> | all] state [enable | disable]
{<vlan_name 32>}
Used to enable the 802.1x server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1x Network Access
control server application on the Switch. To select between port-based
or MAC-based, use the config 802.1x auth_mode command.
(I
NCLUDING
151
24
G VLAN
UEST
)
S