Modify Banner And Prompt Commands - D-Link xStack DES-3500 Series Cli Manual

Administrator level users can modify the login banner (greeting message) and command prompt by using the commands described
below.
Command
config command_ prompt
config greeting_message
show greeting_message
enable greeting_message
disable greeting_message
The Modify Banner and Prompt commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
config command prompt
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To modify the command prompt to "AtYourService":
DES-3500:admin#config command_prompt AtYourService
Command: config command_prompt AtYourService
Success.
AtYourService:admin#
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
M
ODIFY
Parameters
[<string 16> | username | default]
{default}
Used to configure the command prompt.
config command_prompt [<string 16> | username | default]
Administrator level users can use this command to change the
command prompt.
string 16 - The command prompt can be changed by entering a
new name of no more that 16 characters.
username - The command prompt will be changed to the login
username.
default – The command prompt will reset to factory default
command prompt.
Only administrator-level users can issue this command. Other
restrictions include:
•
If the "reset/reset config" command is executed, the
modified command prompt will remain modified. However,
the "reset system" command will reset the command
prompt to the original factory banner.
B
ANNER AND
20
P C
ROMPT OMMANDS
5