Tripp Lite B092-016 Owner's Manual page 99

Alternately you can set the advanced connection and access on the Windows computer to use
the Console Server defaults:

Specify 10.233.111.254 as the From: address

Select Allow calling computer to specify its own address
Also you could use the Console Server default username and password when you set up the
new Remote Desktop User and give this User permission to use the advance connection to
access the Windows computer:

The Console Server default Username is portXX where XX is the serial port number on the
Console Server

The default Password is portXX
So to use the defaults for an RDP connection to the serial port 2 on the Console Server, you
would have set up a Windows user named port02.
 When the PPP connection has been set up, a network icon will appear in the Windows task bar.
Note
The above notes describe setting up an incoming connection for Windows XP. The steps are the
same for Windows 2003, except that the setup screens present slightly differently:
Put a check in the box for Always allow directly connected devices such as palmtop.....
Also, the option to Set up an advanced connection is not available in Windows 2003 if RRAS is
configured. If RRAS has been configured, it is a simple task to enable the null modem connection
for the dial-in configuration
.
99