Configure Dial-In Ppp - Tripp Lite B092-016 Owner's Manual
Console server management switch console server with poweralert console server
Hide thumbs
Also See for B092-016:
- Owner's manual (257 pages) ,
- Quick start manual (4 pages) ,
- Specification sheet (3 pages)
Table of Contents
Advertisement
5.1.1
Configure Dial-In PPP
To enable dial-in PPP access on the Console Server modem port/ internal modem:
Select the System: Dial menu option and the port to be configured (Serial DB9 Port or Internal
Modem Port).
Note
The Console Server's console/modem serial port is set by default to 115200 baud, No parity, 8
data bits and 1 stop bit, with software (Xon-Xoff) flow control enabled. You can modify the baud
rate and flow control using the Management Console. You can further configure the
console/modem port settings by editing /etc/mgetty.config files as described in Chapter 14.
Select the Baud Rate and Flow Control that will communicate with the modem.
Check the Enable Dial-In Access box.
Enter the User name and Password to be used for the dial-in PPP link.
In the Remote Address field, enter the IP address to be assigned to the dial-in client. You can
select any address for the Remote IP Address. However, it and the Local IP Address must both
be in the same network range (e.g. 200.100.1.12 and 200.100.1.67).
61
Advertisement
Table of Contents
