Power: Console Server Management Switch; Network Connection; Serial Port Connection - Tripp Lite B092-016 Owner's Manual

The AC power socket is located at the rear of the B092-016. This power inlet uses a conventional AC
power cord. A North American power cord is provided by default. Power cords for other regions are
available separately from Tripp Lite.
2.2.3

Power: Console Server Management Switch

The B095-004/003 Console Server has an external wall mount power supply. This power supply accepts
AC input voltage between 100 and 240 VAC with a frequency of 50 or 60 Hz and the total power
consumption per console server is less than 20W. The DC power sockets on the B095-004/003 Console
Server are located on the side of the metal case marked PXR.
2.3

Network Connection

The RJ45 10/100 LAN port is located on the rear of the B092-016 Console Server, on the front of the
B096-048/016 Console Server Management Switch and on the side panel of the B095-004/003 Console
Server . All physical connections are made using industry standard Cat5e patch cables (Tripp Lite N001-
and N002-series cables). Ensure you only connect the LAN port to an Ethernet network that supports
10Base-T/100Base-T. For the initial configuration of the Console Server you must connect a computer to
the Console Server's principal network port.
2.4

Serial Port Connection

The RJ45 serial ports are located on the rear of the B092-016 Console Server, on the front of the B096-
048/016 Console Server Management Switch and on the side panel of the B095-004/003 Console
Server. These Console Servers use the RJ45 pinout used by Cisco. Use straight through RJ45 cabling to
connect to equipment such as Cisco, Juniper, SUN, and more.
Conventional Cat5 cabling with RJ45 jacks are used for serial connections. Before connecting the console
port of an external device to the Console Server serial port, confirm that the device supports standard
RS-232C (EIA-232).
The Console Server also has a DB9 LOCAL (Console/Modem) port. This DB-9 connector is on the rear
panel of the B092-016 Console Server, and on the front panel of the B096-048/016 Console Server
Management Switch.
PIN SIGNAL DEFINITION
1 CTS Clear To Send
2 DSR Data Set Ready
3 RXD Receive Data
4 GND Signal Ground
5 GND Signal Ground
6 TXD Transmit Data
7 DTR Data Terminal Ready
8 RTS Request To Send
17
DIRECTION
Input
Input
Input
NA
NA
Output
Output
Output