Tripp Lite B092-016 Owner's Manual page 58

To add a new network connected Managed Device:
 The Administrator adds a new network connected Managed Device using Add Host on the
Serial&Network: Network Host menu. This automatically creates a corresponding new
Managed Device (as covered in Section 4.4 - Network Hosts).
 When adding a new network connected RPC or UPS power device, set up a Network Host,
designate it as RPC or UPS, then go to RPC Connections (or UPS Connections) to configure the
relevant connection. Again the corresponding new Managed Device (with the same Name
/Description as the RPC/UPS Host) is not created until this connection step is completed (refer
Chapter8 - Power and Environment).
Note
The outlet names on this newly created PDU will by default be "Outlet 1" "Outlet 2". When you
connect a particular Managed Device (that draws power from the outlet), the outlet will then take
up the name of the powered Managed Device.
To add a new serially connected Managed Device:
 Configure the serial port using the Serial&Network: Serial Port menu (refer Section 4.1 -
Configure Serial Port ).
 Select Serial&Network: Managed Devices and click Add Device.
 Enter a Device Name and Description for the Managed Device.
 Click Add Connection and select Serial and the Port that connects to the Managed Device.
 To add a UPS/RPC power connection or network connection or another serial connection click
Add Connection.
 Click Apply.
Note
To set up a new serially connected RPC UPS or EMD device, configure the serial port, designate
it as a Device then enter a Name and Description for that device in the Serial & Network: RPC
Connections (or UPS Connections or Environmental). When applied, this will automatically
create a corresponding new Managed Device with the same Name /Description as the RPC/UPS
Host (refer Chapter8 - Power and Environment).
58