Tripp Lite B092-016 Owner's Manual page 21

 You will be prompted to log in. Enter the default
administration username and administration
password:
Username: root
Password: default
The above screen, which lists four initial installation configuration steps, will be displayed:
1. Change the default administration password on the System/Administration page
2. Configure the local network settings on the System/IP page
3. Configure port settings and enable the Serial & Network/Serial Port page
4. Configure users with access to serial ports on the Serial & Network/Users page
After completing each of the above steps, you can return to the configuration list by clicking in the top
left corner of the screen on the logo:
Note
If you are not able to connect to the Management Console at 192.168.0.1 or if the default
Username / Password were not accepted then reset your Console Server (refer to Chapter 10).
(Chapter 3).
21
(Chapter 3).
(Chapter 4).
(Chapter 3).