Tripp Lite B092-016 Owner's Manual page 55
Console server management switch console server with poweralert console server
Hide thumbs
Also See for B092-016:
- Owner's manual (257 pages) ,
- Quick start manual (4 pages) ,
- Specification sheet (3 pages)
Table of Contents
Advertisement
Connect at system startup—When enabled VirtualPort will try to connect to the Console Server
-
when the VirtualPort service starts (as opposed to waiting for the application to open the serial
port before initiating the connection to the Console Server).
The Time between connection retries specifies the number of seconds between TCP connection
-
retries after a client-initiated connection failure. Valid values are 1-255. (The default is 1 second
and VirtualPort will continue attempting to reconnect forever to the Console Server at this
interval.)
The Send keep-alive packets option tests if the TCP connection is still up when no data has been
-
sent for a while. This is done by sending keep-alive messages. Select this option and specify a
period of time (in milliseconds) after which VirtualPort sends a command to the remote
Server
end in order to verify connection's integrity and keep the connection alive.
The Keep-Alive Interval specifies the number of seconds to wait on an idle connection before
-
sending a keep-alive message. The default is 1 second. The Keep-Alive Timeout specifies how
long VirtualPort should wait for a keep alive response before timing out the connection.
Disable Nagle Algorithm — the Nagle Algorithm is enabled by default and it reduces the number
-
of small packets sent by VirtualPort across the network.
55
Console
Advertisement
Table of Contents
