Adjusting Footplate Height - Invacare Orbit Owner's Operator And Maintenance Manual

Adjusting Footplate Height

NOTE: Release the footrest locking mechanism and lift the mounting pin out of the mounting tube.
Lay the assembly on a flat surface to simplify this procedure.
Adjusting Pivot Slide Tube Height
NOTE: For this procedure, refer to FIGURE 5.2.
1. Remove any accessories that are attached to the footrests.
2. Remove the mounting screw and coved washer and position the footrest assembly to
the desired height.
3. Align the mounting hole in the footrest support, reinsert the mounting screw and
coved washer and securely tighten.
4. Repeat STEPS 1‐3 for the other footrest.
5. Reinstall any accessories attached to the footrest.
Adjusting Footplate Height (70° MFX and 90° Footrests Only)
NOTE: For this procedure, refer to FIGURE 5.3 on page 32.
1. Remove any accessories that are attached to the footrests.
2. Remove the mounting screw, coved washer and locknut that secure the footplate to
the footrest support.
3. Reposition the footplate to the desired height.
Part No. 1073955
Mounting Screw
Coved
Washer
Footrest
FIGURE 5.2 Adjusting Footplate Height
31
SECTION 5—FRONT RIGGINGS
Footrest
Support
™
Orbit