SECTION 5—FRONT RIGGINGS
4. Secure the bilateral contracture platform to the seat frame in the mounting position
shown in FIGURE 5.10 with the mounting screws and washers provided. Securely
tighten.
5. Adjust the bilateral contracture platform to the desired height, angle and depth. Refer
to Adjusting Height of Bilateral Contracture Platform on page 36.
6. Install end caps on seat rail.
Removing Bilateral Contracture Platform
1. Remove the mounting screws and
washers that secure the bilateral
contracture platform to the seat frame.
2. Remove the bilateral contracture
platform from the wheelchair.
3. Remove the end caps in the seat rails.
4. Install telescoping tubes. Refer to
Installing/Removing/Adjusting the
Telescoping Front Frame Tubes on
page 38.
5. Install desired footrest. Refer to
Installing/Removing Front Riggings on
page 30.
Adjusting Height of Bilateral Contracture Platform
NOTE: For this procedure, refer to FIGURE 5.11 on page 37.
NOTE: The bilateral contracture platform has six height adjustment options with a range of
11‐16‐inches in height.
1. Remove the mounting screw, spacers and locknut that secure the bilateral contracture
platform to the upper support.
2. Slide the bilateral contracture platform up or down to the necessary height.
3. Reinstall the mounting screw, spacers, and locknuts.
4. Securely tighten the mounting screw and locknut that secure the contracture platform
to the upper support. Repeat for opposite platform.
™
Orbit
Bilateral
Contracture
Platform
Seat
Rail
Mounting
Screw
Locknut
Spacers
FIGURE 5.10 Bilateral Contracture
Platform Procedures
36
Washer
End Cap
Upper
Support
Mounting
Screw
Part No. 1073955