Appendix; Appendix A: Phone-Set Command - PURE M3700 User Manual

12.

Appendix

12.1 Appendix A: Phone-Set Command

Pick up the handset and listen for the dialing tone. Dial "##0000 and listen for three consecutive
tones before setting the following parameters. After input the parameters, please dial '# to end the
configuration.
Note: If Dialing Mode is configured to Transparent, (refer to section 8.1 Dialing Plan) then all digits
you dial is passed to SIP Proxy and all Phone-Set Command is disabled.
Command Description
01 IP State
02 IP Address
03 Subnet Mask
04 Default Gateway
05 Primary DNS Server
IP
06 Second DNS Server
IP
07 Select Signaling Port 0~65535
08 Select RTP Base Port 0~65534 (limit to even port number only)
09 PPPoE username
10 PPPoE password
11 DND
12 SIP Forward State
13 SIP Forward To
Number
14 Change Service Port
Parameters
0 : static; 1: DHCP; 2: PPPoE
xxx*xxx*xxx*xxx
xxx*xxx*xxx*xxx
xxx*xxx*xxx*xxx
xxx*xxx*xxx*xxx
xxx*xxx*xxx*xxx
User name (use the mapping table to map
character into digits)
Password (use the mapping table to map
character into digits)
Do not Disturb, this line accept dial out call only.
All incoming call is terminated. 0 : Disable ; 1:
Enable
0 : Disable ; 1: Enable; 2: Busy; 3: No Answer
The SIP number that this line will forward to. The
Forward To address is "key in phone-set
number@SIP proxy registered". For example,
73796@fwd.pulver.com, 73796 is the number
you key-in by phone-set. fwd.pulver.com is the
registered proxy of this gateway.
1:FTP; 2:HTTP 3:Telnet (Port: 0-65535)
85
M3700
user manual
DCC NO. 91710015011