Static Ip Mode - PURE M3700 User Manual

6.2.1

Static IP Mode

The following table shows an example.
IP Address
Subnet Mask
Default Gateway
Web Management
Password
Using the information contained in the example above. The procedure is as follows:
1. Connect the unit to a suitable Power source.
2. Connect a traditional phone set to the "FXS" connector located on the rear panel.
3. When the CPU/ACT light is on, pick up the phone to hear the dialing tone.
4. ##0000
5. 010#
6. 02210*67*96*121#
7. 03255*255*255*248#
8. 04210*67*96*120#
9. 15123#
10. 981#
11. Hang up the phone. The system should now restart.
You can also use console to configure IP address.
(For Telnet, From Windows, Start
machine.)
SIP-RG>enable
SIP-RG#configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#ip state user
SIP-RG(config)#ip address 210.67.96.121 255.255.255.248
System need to restart
SIP-RG(config)#ip default-gateway 210.67.96.120
SIP-RG(config)#exit
SIP-RG#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes
210.67.96.121
255.255.255.248
210.67.96.120
123
; you should hear three short tones.
; the digit "0" is used to enable "manual" IP mode.
; IP address.
; Subnet Mask.
; Default Gateway.
; "123" is the web management password.
; Warm-restarts.
Run Telnet 192.168.0.2 (192.168.0.2 is the default IP of this
18