Confirming The Region Id; Phone Setting - PURE M3700 User Manual

2. Configure IP address of gateway.
3. Enter into the WEB page.
4. Plan and configure the channels into SIP entity. (if needs. By default, all channels joins Entity 1)
5. Configure SIP proxy and registrar information.
6. Configure SIP entity information.
7. Configure Outbound Authentication (If needs).
8. Configure STUN (If your gateway is behind NAT).
9. Check the SIP entity if is registered successful.
10. Configure Phone book (If needs)
11. Make a SIP call.

6.1 Confirming the Region ID

Skip this step if you are installing your unit in the default region. The default Region ID is printed on
the label located outside the box. If you are installing your unit at any region other then the region ID
specified on the label, you will then need to configure the unit to the correct Region ID. About the
Region ID, please refer to Section 12.5 Region ID.
M3702
Region ID Label
6.1.1

Phone Setting

1. Connect the power.
2. Connect the phone cable to the "Phone" socket on the rear panel as pictured above.
3. When the CPU/ACT LED is on, pick up the handset and listen for the dialing tone.
4. Dial "##0000" and listen for 3 short beep.
5. Dial "9507#"；Assuming you are modifying for China (The last 2 digits are the regional ID)
6. Dial "971#" ；Sets the new regional ID.
7. Hang up the phone. The device will be updated with the new region setting after it restarts
(restart time is about 10 seconds)
16