Dhcp Mode; Pppoe Mode - PURE M3700 User Manual

6.2.2

DHCP Mode

1. Connect the unit to a suitable Power source.
2. Connect a traditional phone set to the "FXS" connector located on the rear panel.
3. When the CPU/ACT light is on, pick up the phone to hear the dialing tone.
4. ##0000
5. 011#
6. 15123#
7. 981#
8. Hang up the phone. The system should now restart.
You can also use console to configure IP address.
(For Telnet, From Windows, Start
machine, change it if the IP is changed.)
SIP-RG>enable
SIP-RG#configure
Enter configuration commands, one per line. End with CNTL/Z
SIP-RG(config)#ip state dhcp
SIP-RG(config)#exit
SIP-RG#restart
This command resets the system. System will restart operation code agent.
Reset system, [Y]es or [N]o? Yes
6.2.3

PPPoE Mode

If your network environment is using PPPoE, you need to prepare the information as specified in
section 5. Information required before Installation.
The following table shows an example.
PPPoE Account
PPPoE Password
Web management password
There are three ways to configure user name and password of PPPoE
6.2.3.1 1. Use phone set to configure:
You can configure the user name and password by using phone set. The command '09' is used for
username and '10' is for password of PPPoE. Since the user name and password use characters
and digits are accepted by phoneset only, you need a mapping between characters and digits. You
; you should hear three short tones.
; the digit "0" is used to enable "DHCP" IP mode.
; "123" is the web management password.
; Warm-restarts.
Run Telnet 192.168.0.2 (192.168.0.2 is the default IP of this
83721@hinet.net
123ab
123
19
M3700
user manual
DCC NO. 91710015011