Table of Contents
Advertisement
5.2 SIP Information
Before configuring SIP, the M3700 requires SIP information for operation. The following table helps
you to decide what information you need.
Items
1. SIP Proxy
2. Public Address (SIP Account)
Example: sip@abc.com
3. Outbound Authentication
5.3 Prepare a password for Web Management
You will need to prepare a password for Web based Management. It can be a digit and/or letter
combination ranging from 1 to 6 digits (E.g. 123). For security reason, password must be set to
enter the Web Management page.
6.
Installation and Configuration
After preparing the information you need as specified in section 5, follow the following steps to do
the basic configuration. You can use either a telephone or a system console to perform basic
configurations. It is simple to connect a telephone set to FXS port and configures the system. If you
want to use system console to configure the system (Only 3704/3708/3716 support), you have to
configure your VT100 terminal to match the settings of the unit's console port. The console port's
terminal connection is set to 9600 baud, 8 data bits, 1 stop bit and no parity. Turn on the unit's power
and wait for the terminal to display "Press Enter..." follow the directions to begin.
Here are several procedures to do:
1. Confirming the Region ID.
Description
If you want to make SIP calls through SIP proxy
server, you will need to know the IP address or
domain name of SIP proxy server. The proxy
server is an intermediate device that receives
SIP requests from a client and then forwards
the requests on the client's behalf. If you don't
know which SIP proxy for setting, contact your
SIP service provider.
The public address is like phone number, you
can get the account from your SIP service
provider.
You will need the information when the SIP
proxy server requires authentication. You can
get this authentication information from SIP
service provider when you apply for the service.
15
M3700
user manual
DCC NO. 91710015011
Advertisement
Table of Contents
