Radio Messages - Hummer H2 2010 Owner's Manual

Undesired XM categories can be removed through the
setup menu. To remove an undesired category:
1. Press the MENU button.
2. Press the softkey below the XM CAT tab.
3. Turn the knob to display the category to be
removed.
4. Press the softkey under the Remove tab until the
category name along with the word Removed
displays.
5. Repeat the steps to remove more categories.
Removed categories can be restored by pressing the
softkey under the Add label when a removed category
is displayed or by pressing the softkey under the
Restore All label.
Categories cannot be removed or added while the
vehicle is moving faster than 8 km/h (5 mph).

Radio Messages

Calibration Error: The audio system has been
calibrated for the vehicle from the factory. If Calibration
Error displays, it means that the radio has not been
configured properly for the vehicle and it must be
returned to your dealer for service.
Locked: This message displays when the
®
THEFTLOCK system has locked up the radio. Take
the vehicle to your dealer for service.
4-78
If any error occurs repeatedly or if an error cannot be
corrected, contact your dealer.
Radio Messages for XM Only
See XM Radio Messages on page 4 104 later in this
section for further detail.
Playing CD(s) (Six-Disc CD Player)
LOAD : Press this button to load CDs into the CD
player. This CD player holds up to six CDs.
To insert one CD, do the following:
1. Press and release the LOAD
Disc and then Insert Disc 1 displays.
2. Insert the CD partway into the slot, label side up.
Loading Disc 1 displays as the disc is being pulled
into the player.
3. Once the CD is loaded, Disc 1 and Track 1 displays
as the CD starts playback.
To insert multiple CDs, do the following:
1. Press and hold the
A beep sounds and Load All Discs displays.
2. Follow the displayed instruction on when to insert
the discs. The CD player takes up to six CDs.
3. Press the button again to cancel loading
more CDs.
button, Load
button for two seconds.