Cutter Protection_Replacement - Roland STIKA SX-15 Service Notes

3-3 CUTTER PROTECTION_REPLACEMENT (Referential Time : 3min.)
Peel off the Cutter Protection from the machine and remove
1
it.
Using a commercially available cutter knife or the like may
make peeling easier.
As for the SX-15, raise the left and right sheet adjustment
levers and remove the Cutter Protection.
Use a cloth or the like to wipe away any remaining
adhesive on the machine.
Place the new Cutter Protection on the Front Table.
2
Use the reference line shown on the SX-15/12/8 as a guide
for alignment.
Peel off the double-sided tape and attach the new Cutter
3
Protection.
As for the SX-15, lower the left and right sheet adjustment
4
levers.
3 Replacement of Main Parts
Reference Line
Sheet Adjust Levers
3
15