Decorative Refractories (Classic & Brick) - FireplaceXtrordinair 36DV Owner's Manual

O
PTIONAL
P 38
AGE
2 Route the thermostat wire through either of the gas inlet holes (you may wish to wrap the wire in
electrical tape where it passes through the fireplace to prevent damage to the wire).
3 Route the thermostat wire to the thermostat location. It is best to choose a location away from the
fireplace and centralized the room, yet within the 50' length of thermostat wire. Run the wire
through the wall at the center location of the thermostat.
4 Cut the thermostat wire so there is approximately 6" of slack (NOTE: Do not splice thermostat wires
together–this leads to too much electrical resistance). Expose approximately 1/2" off each wire of
the thermostat wire. Attach the exposed wire to the clips on the back of the thermostat using a
screwdriver.
Expose 1/2" of wire and attach to the
two connections on the back of the
thermostat (use a screwdriver).
Orientation does not matter.
Back Side of
Thermostat
5 Pull the cover off the thermostat. Place the thermostat in location and attach it to the wall through
the two obround holes (use the appropriate screws for the type of wall it is being attached to).
Replace the cover on the thermostat to complete the installation.
Pull the cover off the
thermostat to expose the
holes for mounting the
thermostat.
E (C
QUIPMENT
)
ONTINUED
Run the thermostat wire through
the wall (cut off excess wire,
leaving 6" of slack)
Wall
Use the appropriate screws to
mount the thermostat to the wall.