Decorative Refractories (Classic & Brick); Altitude Considerations - FireplaceXtrordinair 36DV-AR Owner's Manual

O
PTIONAL
P 44
AGE
Decorative Firebacks
The decorative cast fireback attaches to the walls of the firebox to enhance aesthetics. The directions
below detail its installation.
! Turn the gas control valve to "OFF" prior to conducting any service.
1 The faceplate, glass, and log set must be removed prior to installing the decorative firebacks. See
pages 24 through 25, and the instructions included with the face for instructions.
2 Use a 5/16" nutdriver to remove the ten screws shown in the illustration below (the screws included
with the kit screw into these holes).
3 Line up the holes in the plates with the corresponding holes in the firebox walls. The side plates are
marked "Left" and "Right" on the back to differentiate the two sides. Insert the screws included with
the kit through the plates and into the walls of the firebox to secure the plates in place.
Fireplace with faceplate,
glass, and log set removed

Altitude Considerations

This fireplace has been tested at altitudes ranging from sea level to 8,000 feet. In this testing we have
found that the fireplace, with its standard orifice, burns correctly with just an air shutter adjustment. For
information on adjusting the air shutter see page 27 of this manual.
! Failure to adjust the air shutter properly may lead to improper combustion which can create a
safety hazard. Please consult your dealer or installer if you suspect an improperly adjusted air
shutter.
E (C
QUIPMENT
(Part # 98500733)
)
ONTINUED
Remove the ten
screws on the walls of
the firebox shown in
this illustration. Place
the fireback plates
against the walls of the
firebox so the holes in
the plates line up with
the holes in the
firebox. Insert the
screws included with
the fireback kit to
secure the plates in
place (use a flat head
screwdriver).
A
DDENDUM