Thermostat (Part # 99300650) - FireplaceXtrordinair 36DV Owner's Manual

4 The remote control receiver is mounted to the wall and requires a hole 1-3/4" wide by 2-1/2" high.
Choose a location near the fireplace that may be reached with the 50' length of remote control wire.
Cut the hole and route the remote control wire through this hole. Attach the remote control wire to
the remote control receiver by inserting the quick-connects together.
Cover Plate
The distance between the
mounting holes is 3 1/4".
The mounting screws insert here
(screws not included)
Thermostat
(Part # 99300650)
The thermostat allows the fireplace to turn on and off automatically for consistent room temperature.
! Do not connect 110-120 VAC to the gas control valve or control wiring system of this unit.
? The directions below detail a thermostat that is hooked up in "series" with the main burner electrical
circuit. The ON/OFF switch must be left "ON" for the thermostat to operate (when turned to "OFF",
the fireplace is always off). NOTE: some installers prefer to hook the thermostat up "parallel" with
the main burner electrical circuit. This type of installation allows the ON/OFF switch to over-ride
the thermostat and turn the fireplace on, even if the thermostat does not call for heat. Make sure the
home owner is aware of how the thermostat works in conjunction with the ON/OFF switch.
1 Open the access door. Remove and discard the green jumper wire (see the illustration below).
Attach the thermostat wire to the top two posts of the on/off switch.
+ It is easiest to route the thermostat wire prior to installing the fireplace. Route the wire to a location
near the gas inlet. Allow 3' of wire for hookup inside the fireplace.
Thermostat
Wire
Fireplace
Gas Inlet
Hole
O
Remote Control
Receiver
Side of
Green
Jumper
Wire
Look behind the on/off switch and locate the green jumper wire
that attaches to the top two posts of the on/off switch.
Remove and discard the jumper wire and attach the thermostat
wire to the two posts the jumper wire was attached to. Route
the thermostat wire through the gas inlet hole.
Faceplate
E
PTIONAL QUIPMENT
The hole must
be 1 3/4" wide.
The hole must
be 2 1/2" tall.
Remote
Control Wire
Thermostat
Wire
4 1
5 2
Back of on/off switch
(C )
ONTINUED
P
PILOT
ON
IGNITER
OFF
37
AGE