Electrical Connection; Installation (Continued); Finalizing The Installation - FireplaceXtrordinair 36DV Owner's Manual

Electrical Connection

! Make sure the household breaker is shut off prior to working on any electrical lines.
! The fireplace must be properly grounded in accordance with local codes (or ANSI/NFPA 70-1987)
• The electrical line must be 14 gauge, and supply 115 Volts at 60 Hz (2 Amps)
1 Remove the junction box cover at the right rear corner of the fireplace near the base.
2 Feed the electrical line through the strain relief (use insulated Romex (®) type wire).
3 Remove the wires from the junction box. Expose approximately 1/2" of metal wire from each line of
the electrical line. Use the wire nuts (included in the owner's pack inside the firebox) to secure the
wires together. Connect the green wire to the ground wire (usually green), the white wire to the
common wire (usually white), and black wire to the hot wire (usually black).
4 Push the wire connections into the junction box. Replace the cover plate.
5 Tighten the strain relief on to the outer insulation of the electrical line to insure the line does not pull
loose.

Finalizing the Installation

! Turn the gas control valve to "OFF" prior to conducting any service.
! ACID WASH WARNING: Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid
wash (muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia
solution, the gold face may develop a permanent tarnish when the acid evaporates over time.
Contact your dealer if uncertain your facing has been properly neutralized.
1 Use the #3 square drive included with the fireplace to remove the 5 bolts holding the set-up face in
place. Remove and discard the set-up face.
I (C
NSTALLATION
.)
ONT
P 21
AGE