Table of Contents
Advertisement
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1)
Press as to select [LOAD ALL USER DATA].
2)
Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3)
Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
4)
Press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f The data loaded from [LOAD ALL USER DATA] does not include the data set with "Geometric & Setup Management Software".
[HDMI CEC]
Sets the CEC (Consumer Electronics Control) function of HDMI.
CEC is a function that is realized by exchanging device control signals with external devices connected with
an HDMI cable. Using the remote control of the projector, it is possible to operate the CEC-compatible external
device (hereinafter referred to as "CEC‑compatible device") and to control the power on/off link status between
the projector and the CEC-compatible device.
For details on how to use the CEC function, refer to "Using HDMI CEC function" (x page 257).
1)
Press as to select [HDMI CEC].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Operating a CEC-compatible device
Operate the CEC-compatible device connected to the <HDMI IN 1> terminal, <HDMI IN 2> terminal or Function
Board.
[HDMI-CEC OPERATION] can be operated when HDMI1 input, HDMI2 input or SLOT input is selected. Switch to
the input that is corresponding to the CEC-compatible device you want to operate in advance.
1)
Press as to select [HDMI CEC].
2)
Press qw to select [ON].
3)
Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4)
Press as to select [HDMI 1], [HDMI 2] or [SLOT].
f Select the input corresponding to the CEC-compatible device you want to operate.
f [SLOT] can be selected when the Function Board is installed in the slot.
f Proceed to Step 6) when the device to operate is displayed.
5)
Press qw to switch the item.
f The devices will switch when multiple CEC-compatible devices are connected to one input.
f Select the device to operate.
6)
Press as to select [HDMI-CEC OPERATION].
7)
Press the <ENTER> button.
f The HDMI CEC operation screen is displayed.
8)
Select the item displayed on the HDMI-CEC operation screen to operate the device.
f Refer to the "Using HDMI CEC function" (x page 257) for the operation details.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the CEC function.
Enables the CEC function.
ENGLISH - 187
Advertisement
Table of Contents
