Running Sequence - Panasonic System 850 Operating Instructions Manual

Running Sequence

Tour Sequence
The following functions are available only if a Tour
Sequence has been previously established through the
Administration Console. As described on the setup, any of
the tours can be assigned to any of the monitors.
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the desired Tour Sequence Number by pressing
the numeric buttons.
3. Pressing the [TOUR SEQ] button will run the tour
sequence in forward direction on the active monitor.
The selected Tour Sequence Number (T8) with "R" sign
(indicate running status) is displayed on the active
monitor.
PREV
S-CTL ID
PAUSE
CAM MENU OFF CAM MENU ON
GROUP
SEQ
OSD
4. Press the [PAUSE] button to pause a Tour Sequence
that is being run on the active monitor.
The "P" sign (indicating the pause status) is displayed
at the Tour Sequence Number on the active monitor,
and a camera number currently selected is displayed
on the LED display.
5. Press the [TOUR SEQ] button to restart a Tour
Sequence forward from the next step that was previ-
ously paused by pressing the PAUSE button.
6. Press the [TOUR SEQ] button while holding down the
[SHIFT] button to restart a Tour Sequence backward
from the next step that was previously paused by
pressing the PAUSE key.
7. Press the [NEXT] button to move the sequence one
frame to the next step (in forward or reverse run direc-
tion) from the step that was previously paused by
pressing the PAUSE button.
110
NEXT T&D CAM ID GEN
AUX1 OFF AUX1 ON WIPER
ALM S VLD S SYS S
STOP MON STATUS ALL
AUX2 OFF AUX2 ON
TOUR ALM H VDL H
SEQ
DEF OFF DEF ON
CLEAR
( ESC )
MONITOR
SHIFT BLK EXIT
LOCK
OSD SERVICE
8. Press the [PREV] button to move the sequence one
frame to the previous step (in forward or reverse run
direction) from the step that was previously paused by
pressing the PAUSE button.
9. To return to Spot monitoring, press the [STOP] button
to end a Tour Sequence that is being run on the active
monitor.
Call Group Preset
The following function is available only if a Group Preset
has been previously established through the Administration
Console.
1. As described earlier, a Group Preset determines which
monitor is to be assigned to which camera. Therefore,
selecting a monitor is not required.
2. Select a desired Group Presets Number by pressing
the Numeric buttons.
3. Press the [GROUP PRESET] button to activate a
selected Group Presets function.
The selected preset positions of the cameras are dis-
played on the assigned monitors at a time.
GROUP PRESET PREV NEXT
OPE ID S-CTL ID
LOG OUT PAUSE STOP
CAM MENU OFF CAM MENU ON
GROUP
TOUR
F1 SEQ
SEQ
F2
OSD MONITOR
CAM FUNC LOCK
OSD SERVICE
T&D CAM ID GEN
AUX1 OFF AUX1 ON WIPER
ALM S VLD S SYS S
MON STATUS ALL
AUX2 OFF AUX2 ON
ALM H VDL H
DEF OFF DEF ON
CLEAR
( ESC )
SHIFT BLK EXIT