Alarm Control - Panasonic System 850 Operating Instructions Manual

Alarm Control

When cameras and monitor are armed for alarm response
with an alarm inputs, the camera pictures associated with
that alarm input is displayed on the monitor when the alarm
is received.
When an alarm is received, the ALARM indicator lights. The
indicator remains lit until all alarms are cleared by pressing
the RESET button.
Alarm Arming Control
1. Select an alarm number by pressing the numeric but-
tons, followed by the [ALARM] button.
ALARM
ACK
DISARM
GROUP PRESET
PREV
OPE ID S-CTL ID
LOG OUT
PAUSE
CAM MENU OFF
GROUP
F1 SEQ
F2
OSD
CAM FUNC
2. Pressing the [ALARM] button repeatedly will arm or
disarm cameras and monitor for alarm response with
the selected alarm.
The DISARM indicator will light on the controller when
the alarm disarm mode is selected.
3. Pressing the [NEXT] button while holding down the
[ALARM] button will select the next higher alarm num-
ber, or pressing the [PREV] button while holding down
the [ALARM] button will select the next lower alarm
number.
4. Pressing the [ALARM] button repeatedly will arm or
disarm cameras and monitor for alarm response with
the selected alarm.
5. To exit from alarm selecting mode, press the [CLEAR
(ESC)] button.
117
RESET
ALL RESET
NEXT
T&D CAM ID GEN
AUX1 OFF AUX1 ON WIPER
ALM S VLD S SYS S
STOP
MON STATUS
ALL
CAM MENU ON
AUX2 OFF AUX2 ON
TOUR
ALM H VDL H
SEQ
DEF OFF DEF ON
CLEAR
( ESC )
MONITOR
LOCK
SHIFT BLK EXIT
OSD SERVICE
To Cancel Alarms
1. Select an activated alarm number that is displayed on
the active monitor by pressing the numeric buttons, fol-
lowed by the [ALARM] button.
2. Select the alarm action number by pressing the numer-
ic button, then press the [ACK] button to acknowledge
the activated alarm manually.
The acknowledged alarm picture is displayed on the
active monitor, and the ACK indicator on the controller
is turned on.
Note: By the factory default setting, pressing only the
[ACK] button will interpret it as the alarm action #0.
3. After acknowledging the alarm, press the [RESET] but-
ton to reset the alarm.
The ACK indicator will go off.
ALARM
ACK RESET
DISARM
ALL RESET
GROUP PRESET PREV NEXT
OPE ID S-CTL ID
LOG OUT
PAUSE STOP
CAM MENU OFF CAM MENU ON
GROUP TOUR
F1 SEQ
SEQ
F2
OSD MONITOR
CAM FUNC LOCK
OSD SERVICE
Note: All reset function is available without selecting
the activated alarms. Pressing the [RESET] button
while holding down the [SHIFT] button will cancel
all currently activated alarms at once.
T&D CAM ID GEN
AUX1 OFF AUX1 ON WIPER
ALM S VLD S SYS S
MON STATUS ALL
AUX2 OFF AUX2 ON
ALM H VDL H
DEF OFF DEF ON
CLEAR
( ESC )
SHIFT BLK EXIT