Oki ES8430 User Manual page 40

ITEM
HDD Setup Resize
(cont.) Partition
Format
Partition
System Near Life
Setup Status
Near Life
LED
SETTINGS EXPLANATION
PCL nn%/ Specifies the size of partition. Specifies a size by ratio to
Common mm%/ the whole HDD in % (1% unit).
PSll%/<Apply>
nn,mm,ll: 1 - 98 and nn+mm+ll=100
The sizes are displayed in the partition list and can be
changed by selecting the partition size to be changed. If
Apply is selected, the following confirmation message
appears.
Are You Sure? Yes/No
If No is selected, you will return to the previous menu.
If Yes is selected, the following confirmation message
appears.
Execute Now? Yes/No
If No is selected, you will return to the previous menu.
The request to execute the partition size change request
is put into the memory and the hard disk initialization and
partition size change will be executed at next power cycle.
If Yes is selected, shutdown takes place. Hard disk
initialization and partition size change will be executed at
Power Off/On cycle. (If one partition size is modified, the
others are also modified.) If any partition size is modified,
Initialization of HDD needs to be executed as well.
If a previously used HDD is installed, HDD initialization
also takes place. If a HDD, which has been used before, is
installed, the layout of this menu may be different from
that of each partition. (The previously used layout will be
displayed.)
In Non-PS machines, PS is replaced by COMMON, so the
message is displayed as "PCL/COMMON/COMMON".
PCL Formats a specified partition.
Common When the Enter button is pressed, the following
confirmation message appears.
PS
Are You Sure? Yes/No
If No is selected, you will return to the previous menu.
If Yes is selected, the following confirmation message
appears.
Execute Now? Yes/No
If No is selected, you will return to the previous menu.
The request to execute partition formatting is put into the
memory and formatting will be executed at next power
cycle.
If Yes is selected, shutdown takes place and the partition
is formatted at power Off/On cycle.
In Non-PS machines, PS is replaced by Common, so the
message is displayed as "PCL/Common/Common".
Enable/Disable Sets the LCD display control whennear life warning of a
drum, fuser or trancfer belt occurs.
ATTENTION LED is lit if ENABLED
Enable/Disable Controls the settings of the Attention LED when near end
of life warning of toner, drum, fuser, or belt occurs.
Attention LED is lit when enabled, not lit if disabled.
(Displays LCD message.)
The temporary recovery by opening and closing of the
cover in Life error is not included.
Menu functions > 40