Table of Contents
Advertisement
>
IMPORTANT: Set paper size dial (3) to
the size and orientation of paper being
used (A4 LEF in the above example).
5.
If you have two trays and you are printing from the 1st (upper) tray, you can pull
out the 2nd (lower) tray during printing to reload it. However, if printing from the
2nd (lower) tray, do not pull out the 1st (upper) tray. This will cause a paper jam.
If 3 trays are fitted this applies to trays 1 & 2 if printing from the 3rd (lower) tray.
6.
For face down printing, make sure the face up (rear) stacker (3) is closed (the paper
exits from the top of the printer). Stacking capacity is approximately 250 sheets,
depending on paper weight.
7.
For face up printing, make sure the face up (rear) stacker (3) is open and the paper
support (4) is extended. Paper is stacked in reverse order and tray capacity is
approximately 100 sheets, depending on paper weight.
8.
Always use the face up (rear) stacker for heavy paper (card stock etc.).
Do not open or close the rear paper exit while printing as it may
result in a paper jam.
CAUTION!
CAUTION!
Loading paper > 13
Advertisement
Table of Contents
