Oki ES8430 User Manual page 34

ITEM
PCL Setup Font Source
Font
Number
Font Pitch
Symbol Set
A4 Print
Width
White Page
skip
CR Function
LF Function
Print Margin
SETTINGS EXPLANATION
Resident Specifies the location of PCL default font.
I0 ~ I90 Sets the PCL font number.
The valid range of this variable changes depending on the
FONT SOURCE setting at the time. If the default font is
set for FONT SOURCE, the number starts at 0. If it is not,
the number starts at 1. The maximum value is equal to
the number of fonts installed in FONT SOURCE.
99.9 CPI Width of the PCL default font in characters per inch (CPI).
Default font is fixed-pitch, scalable font.
~
The value of pitch is displayed down to the second
10.00 CPI
decimal place.
~
Displayed only when the font selected in Font No. is a
0.44 CPI
fixed-spacing, scalable font.
PC-8 Sets the symbol set of PCL (see machine operator panel
for complete list).
78 column Sets the number of characters for A4 paper.
80 column Auto LF.
This is for 10-CPI characters when Auto CR/LF Mode is set
to OFF.
This menu is enabled only when A4 paper is selected in
the menu that sets the print width of A4 paper in portrait
orientation.
Usually, such A4 paper print width is set slightly narrower
than 8 inches (about 7.93 inches).
This setting cannot print 80 10-cpi characters (only prints
up to 78 10-cpi characters). 80 characters set at A4 Print
Width widen the right and left margins.
A PCL command selects or selects/deselects Auto CR/LF
mode.
On/Off Sets whether to eject a page without any data to print
(blank page) upon reception of FF command (OCH) in PCL
Mode. OFF: Ejecting.
CR/CR+LF Sets action when CR code is received in PCL.
CR: Carriage Return
CR+LF: Carriage Return and Line Feed
LF/LF+CR Sets action when LF code is received in PCL.
LF: Line Feed
LF+CR: Line Feed and Carriage Return
Normal Sets a non-printable area of paper.
1/5 inch The width of the area along the right and left sides of
paper (left and right sides depend on paper orientation).
1/6 inch
NORMAL: PCL emulation compatible, approximately 1/
4~1/4.3INCH (depending on paper) is outside the
printable area.
Menu functions > 34