Installation; Power And Temperature Knobs - Mira Vie Installation And User Manual

Warning! Isolate the electrical and water supplies before commencing installation.
The electricity must be turned off at the mains and the appropriate circuit fuse
removed, if applicable.
DO NOT turn-on the electrical supply until the plumbing has been completed.
1. Determine a position for the shower,
at least 200 mm from the ceiling.
2. Put the installation template on the
wall and mark the positions of the
top two fixing holes. Make sure that
there are sufficient lengths of supply
pipe and electrical cable to reach the
connection points as shown on the
template.
3. Remove the installation template and
drill the top and side fixing holes. Insert
the supplied wall plugs.
Caution! Do not drill into cables or pipes
in the wall.
4. Thoroughly flush the supply pipe.
5. On the shower, turn the Power
and Temperature Knobs to the full
anti-clockwise position.
6. Remove the three retaining screws
that hold the cover on the shower and
remove the cover.
7. Remove the service tunnel from the
shower.
8. Determine the direction of the incoming
water supply: falling (entering the
shower from the top), or rising (entering
the shower from the bottom).
Do not use an incoming supply entering
the shower directly from the back. Add
an elbow to the supply pipe and connect
it as a rising or falling supply.
9. Rotate the inlet connector to suit the
direction of the incoming water supply.

INSTALLATION

Shower
15
Service Tunnel
Retaining Screw
Retaining Screws
Inlet Connector