To Access The Local Configuration Menu On A 200X Ip Telephone - Nortel BCM50 Installation And Configuration Manual

To access the local configuration menu on a 200X IP telephone

1 Restart the telephone by disconnecting the power, then reconnecting the power.
After about four seconds, the top light flashes and
2 When the greeting appears, immediately, and quickly, press the four display buttons, one
at a time, from left to right. These buttons are located directly under the display.
Press the button sequence within 1.5 seconds or the telephone does not enter
configuration mode.
• If
Manual Cfg DHCP(0 no, 1 yes)
the configuration mode.
• If any other message appears, disconnect, then reconnect the power, and try to access the
configuration mode again.
3 Enter the network parameters, as prompted.
a
As each parameter prompt appears, use the keypad to define values.
b Use the * key to enter the period in the IP addresses.
OK
c Press
d The following table describes the values for each display parameter.
Table 10 IP telephone server configurations (Sheet 1 of 2)
Field Value
DHCP 0 or 1
If DHCP = 0
SET IP <ip address>
NETMASK <subnet mask
address>
to move forward.
Description
Enter 0 if your network is not using a DHCP server to dispense
IP addresses. (Partial DHCP)
Enter 1 if your network does use a DHCP server.
If you choose to use a DHCP server rather than allocating static
IP addresses for the IP telephones, skip the remainder of this
section.
The set IP must be a valid and unused IP address on the
network to which the telephone is connected.
This is the subnet mask. This setting is critical for locating the
system you want to connect to.
BCM50 IP Telephone Installation and Configuration Guide
Chapter 5 Registering Nortel 20XX IP telephones
NORTEL NETWORKS
Display buttons
appears on the screen, you successfully accessed
45
appears on the screen.