Appendix; Clearing The Program Memory - Toro TMC-212 User Manual

373-0319 TCM 212 Doc2 12/20/04

Appendix

Clearing the Program Memory

Once programmed, the TMC-212 memory will be
retained for several years with or without power. Only
the current time and date will be lost and will need to be
reset if power is interrupted for more than 24 hours.
The programmable memory can be cleared and reset
to the default settings of individual programs or
all programs simultaneously.
(Refer to the default settings listed on page 21.)
IMPORTANT: This procedure permanently erases
the programmable watering information and can not be
restored once the procedure has been completed.
To clear the memory of a selected program (Example 1)
Turn the control dial to the
position.
Check the
PROGRAMS
reposition the switch to select the desired program.
Press the
NEXT
feature; CL will be displayed and begin flashing.
Press and hold the –/
ing (approximately five seconds). The memory will
be cleared to the default settings.
5. To clear the memory of another program, repeat all
of the steps starting at step
Return the control dial to the
36
12:30 PM Page 36
SEASON ADJUST
switch setting. If necessary,
button to access the clear memory
button until CL stops flash-
OFF
.
position.
RUN
Example 1
Example 2
To clear the memory of all programs (Example 2)
Turn the control dial to the
Press the button to access the clear memory
NEXT
feature; CL will be displayed and begin flashing.
Press and hold the –/ button until CL stops flash-
OFF
ing (approximately five seconds). The memory will
be cleared to the default settings.
Return the control dial to the
position.
OFF
position.
RUN