Toro TMC-212 User Manual page 31

373-0319 TCM 212 Doc2 12/20/04
• PS/MV Circuit Enabled During Well Recovery (Yes)
This timing control feature enables the PS/MV circuit to
be active (Yes) or inactive (No) during a Well Recovery
/Station Delay time period.
Note: Refer to Appendix A on page 40 for typical examples
of the PS/MV circuit and Well Recovery timing control
features in use.
Example 1
Turn the control dial to the
position. See Example 1.
Check the
PROGRAMS
reposition the switch to select the desired program.
3. The display will show P On (Pump On) and will
begin flashing.
To disable the PS/MV circuit operation for this
program, press the –/
OFF
will be displayed.
Press the button to display the Pump Delay
NEXT
time. Pd 02 (two-second delay) will be displayed.
Press the +/ or –/
ON OFF
duration from 02 to 60 seconds.
12:30 PM Page 29
SPECIAL FUNCTIONS
switch setting. If necessary,
button; P OFF (Pump Off)
button to select a delay time
Press the button to display the Well Recovery
NEXT
delay time. The Well Recovery
(zero seconds) will be displayed. See Example 2.
Example 2
Seconds Minutes
Press the +/ or –/ button to set the recovery
ON OFF
or station delay duration from 02 to 60 seconds or
01 to 60 minutes. The display will change from
S (seconds) to M (minutes) as the time is increased
past 60 seconds.
Note: The Well Recovery
when this timing control feature is used.
( )
CONTINUED
symbol and S 00
symbol will be displayed
29