Appendix; Clearing The Program Memory - Toro TCM-212 User Manual

373-0402 TMC-212 UG-E:373-0319 TCM 212 Doc2 8/5/08 10:06 AM Page 36

Appendix

Clearing the Program Memory

The user-defined watering program information stored in
the TMC-212 memory will be retained for several years.
If controller power is lost for more than 24 hours, only the
time and date will need to be reset.
If for any reason you wish to clear the user-defined water-
ing program information, two methods are provided:
• Clear and reset a selected program to default settings.
(Default settings for Program A provide one daily auto-
matic watering cycle.)
• Clear and reset all programs simultaneously to off.
(All programs are turned off.)
IMPORTANT: These procedures permanently erase
all user-defined program information that cannot be
recovered once the procedure has been completed.
• To clear and reset memory of a selected program:
36
- Turn the control dial to
All manuals and user guides at all-guides.com
%.
SE SON DJUST
- Position the
PROGR MS
- Press the button once; CL will be displayed
NEXT
and begin flashing.
- Press and hold the –/
flashing (about five seconds). The memory will be
cleared and reset to the factory default settings.
5 - To clear the memory of another program, repeat
all of the steps starting at step
- Return the control dial to the
• To clear the memory of all programs:
- Turn the control dial to the
- Press the button to access the clear memory
NEXT
function; CL will be displayed and begin flashing.
- Press and hold the –/
flashing (approximately five seconds). All programs
will be cleared simultaneously and turned OFF.
- Return the control dial to the
switch setting as necessary.
button until CL stops
OFF
.
position.
RUN
position.
OFF
button until CL stops
OFF
position.
RUN