KTM 690 Enduro R EU Owner's Manual page 64

TUNING THE CHASSIS
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
–
Loosen locking ring
–
Turn adjusting ring
Hook wrench (T106S)
–
Measure the overall spring length without a load.
–
Tension the spring by turning the adjusting ring
Guideline
Spring preload
201271-11
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
–
Tighten locking ring
–
Install the shock absorber.
x
.

until the spring is no longer under tension.


20 mm (0.79 in)
.

x
to the prescribed value.
62