Removing The Engine Guard - KTM 690 Enduro R EU Owner's Manual

SERVICE WORK ON THE CHASSIS

Removing the engine guard

10.21
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top level of container
» If the level of the coolant does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
Hydraulic fluid (15) (
100281-10
–
Position the cover with the membrane. Mount and tighten the screws.
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Remove screws
–
Pull the engine guard forward out of the holders and set it down.
100198-10
.

with membrane .
 
p. 178)
on the left and right.

4 mm (0.16 in)
85