Network/Ports Menu - Konica Minolta Bizhub 3320 User Manual

Network/Ports menu

Active NIC menu
Use
Active NIC
Auto
[list of available network cards]
Standard Network or Network [x] menu
Note: Only active ports appear in this menu. All inactive ports are omitted.
Use
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
NPA Mode
Off
Auto
User's Guide
To
Notes:
• Auto is the factory default setting.
• This menu item appears only when an optional network card is installed.
To
Set the printer to automatically switch to PCL emulation when a print job
requires it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• If PCL SmartSwitch is disabled, then the printer does not examine
incoming data and it uses the default printer language specified in the
Setup menu.
Set the printer to automatically switch to PS emulation when a print job requires
it, regardless of the default printer language.
Notes:
• On is the factory default setting.
• If PS SmartSwitch is disabled, then the printer does not examine incoming
data and uses the default printer language specified in the Setup menu.
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
- 120 -