Konica Minolta Bizhub 3320 User Manual page 8

Use only the power cord provided with this product or the manufacturer's authorized replacement.
CAUTION—TIPPING HAZARD: Floor-mounted configurations require additional furniture for
stability. You must use either a printer stand or printer base if you are using a high-capacity tray and an
input option, or more than one input option. If you purchased a multifunction printer (MFP) that scans,
copies, and faxes, you may need additional furniture.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug
the power cord from the electrical outlet before continuing. If you have any other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.
CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two
or more trained personnel to lift it safely.
CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid
personal injury or printer damage:
• Turn the printer off using the power switch, and then unplug the power cord from the electrical outlet.
• Disconnect all cords and cables from the printer before moving it.
• If an optional tray is installed, then remove it from the printer. To remove the optional tray, slide the
latch on the right side of the tray toward the front of the tray until it clicks into place.
• Use the handholds located on both sides of the printer to lift it.
• Make sure your fingers are not under the printer when you set it down.
• Before setting up the printer, make sure there is adequate clearance around it.
SAVE THESE INSTRUCTIONS.
User's Guide
- 8 -