Omron Powli BU50SW Instruction Manual page 35

3
. Operation
4. Displays and beeps when there is an equipment failure (Continued)
Power supply
Status
No.
output
indicator
17
18
19
20
21
22
——
23
Note 1: In bypass operation, commercial power is output directl
occurs in bypass operation.
Note 2: Fan replacement performed by the user does not comply w
Note 3: The displays and operations vary according to the stat
5. Display and beep for battery replacement
24
6. UPS operation mode setting display
——
——
——
——
——
——
22
Bypass
Battery
operation Beep
replacement
Continuous
Continuous
Continuous
Continuous
Continuous
Continuous
——
Continuous
Intermittent
2-second
intervals
—— —— ——
—— —— ——
—— —— ——
—— —— ——
—— —— ——
—— —— ——
Charging Description
Moved to bypass operation due
—— to output voltage error (under)
Moved to Battery Mode due to
—— battery charge voltage error (over).
Output will stop when the battery is dead.
Output stopped because the
—— output of the battery charge
voltage short-circuited.
Moved to bypass operation due
——
to problem with the internal
temperature (Note 1).
Moved to bypass operation due
—— to bypass bus voltage error
Moved to bypass operation due
—— to problem with the internal
(BU150SW only) (Note 1).
(1) Output stopped due to
——
system error.
(2) Other error occurred.
The battery test detected
a weak battery
ON
(warning only, output continues).
——
——
——
——
——
——
( indicates the display is OFF)
( indicates the display is ON)
( indicates blinking)
Solution
Displays the details of the error that
occurred only while pressing the beep
stop switch while in state No. 15.
(Same as above.)
(Same as above.)
(Same as above.)
(Same as above.)
(Same as above.)
(Same as above.)
Replace the battery.
You can replace the weak battery
with a separately purchased
replacement battery as needed.
——
——
——
——
——
——