Table of Contents
Advertisement
Optional M.A.P. (Mobile Accessories Protection)
This system can be programmed to provide Crimestopper's unique M.A.P. (Mobile Accessories Protection)
feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or
Entertainment systems. This feature is OPTIONAL and will requires extra parts and labor for installation.
Consult your installation dealer about MAP before or during installation.
programmed for MAP operation. When the system is put into Valet Park mode, M.A.P. will prevent stereo,
entertainment, navigation, or cellular system from being used. Basic M.A.P. wiring information is provided in
the installation manual.
The CS-2012DP-TW1 system includes disarm diagnostics, through the RED LED light, that will help in
determining what caused the last trigger of the alarm system. This is a valuable tool in determining how the
vehicle was tampered with or if there is a false alarm problem in which case you can make the necessary
adjustments to correct the problem. When the system is disarmed with the remote you will hear the normal 2
chirps, then 4 quick chirps that indicate the alarm was triggered while you were away. Check the LED light for
a sequence of flashes:
Shock Sensor = 1 Flash
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.
REMOTE ENGINE STARTING - SUCCESSFUL START
1) Press and release the remote start button for at least 1 second. System will chirp 3 times for audible
confirmation. (Chirps can be programmed on or off-See Option programming in the installation manual.)
2) Parking lights flash once, then turn on solid, Ignition/Accessory circuits turn on.
3) After 6 seconds Starter Motor engages, Parking lights and Accessory circuits turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Accessory turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can
be turned off with remote transmitter.
OPERATING INSTRUCTIONS - ALARM
LED DIAGNOSTICS
Door = 2 Flashes
REMOTE ENGINE CONTROL
Hood/Trunk = 3 Flashes
9
The CS2012TW1 must be
Ignition = 4 Flashes
Advertisement
Table of Contents
