Transceiver / Remote Control Programming - CrimeStopper SP-402 Operating Instructions Manual

TRANSCEIVER / REMOTE CONTROL PROGRAMMING

Note: All transmitter codes must be learned at time of programming! This system learns up to 4
different transmitter codes.
1. Turn ignition key to the ON position.
2. Press Programming button 4 times, then after a few seconds the unit flashes the parking lights 4 times.
3. Press button #1 of the first transmitter. You should get 1 light flash confirming the remote is coded, then
press button #1 of a second transmitter, the unit will flash 2 times confirming the remote is coded and so
on. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off.
See diagram below.
OFF
PRESS LOCK
IGN
PRESS 4X's
FLASH 2, 3, or 4 X's
OFF
16
WAIT FOR
4 FLASHES
IGN
COMPLETE