Buick LaCrosse 2011 Owner's Manual page 237

Using the Digit Dial Command
The digit dial command allows a
phone number to be dialed by
entering the digits one at a time.
After each digit is entered, the
system repeats back the digit it
heard followed by a tone.
If an unwanted number is
recognized by the system, say
Clear at any time to clear the
last number.
To hear all of the numbers
recognized by the system,
say Verify at any time.
1. Press . For vehicles with a
navigation system, say Hands
Free after the tone.
2. Say Digit Dial.
3. Say each digit, one at a time,
that you want to dial. After each
digit is entered, the system
repeats back the digit it heard
followed by a tone. After the
last digit has been entered,
say Dial.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re dial Command
1. Press . For vehicles with a
navigation system, say Hands
Free after the tone.
2. After the tone, say Re dial.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
Press to answer the call.
Press to ignore a call.
I n f o r ma t i o n P r o v i d e d b y :
Infotainment System
Call Waiting
Call waiting must be supported on
the cell phone and enabled by the
wireless service carrier.
Press to answer an
incoming call when another
call is active. The original
call is placed on hold.
Press again to return to the
original call.
To ignore the incoming call,
no action is required.
Press to disconnect the
current call and switch to the call
on hold.
7-57