Change Display (Command + 4 + 9) - Bosch D1260 Owner's Manual

CHANGE DISPLAY (COMMAND + 4 + 9)

This function presents three options. One is to dim the display, one to brighten the display, and one to continuously
show the time and date in the display.
Brighten/Dim Display
You can change your command center's display to make the backlit LCD display bright or dim. When the display is dim,
the tones are softer than when the display is bright. Use this option for command centers in bedrooms where a brighter
display and louder tones could interfere with sleep.
If you dim the command center backlit display and an alarm or trouble condition arises, the display automatically
brightens and the volume increases. The backlit display returns to dim lighting when you clear the alarm or trouble
condition.
Show Continuous Time/Date
Use this function to replace the disarmed idle text with a continuous time and date display and to prevent a passersby
from knowing the status of your system.
Any time your command center has an event to display, the time and date display is automatically removed. To return
the time and date display, you must perform this function again.
1. Ensure your command center shows idle disarmed
text.
2. Press the COMMAND key.
3. The display shows *System Command*.
4. Press the 4 and then the 9 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the CHG DISPLAY ?> prompt then press the
adjacent soft key.
5. The display changes to show the display options:
Bright Display> -
Dim Display> -
© 2003 Bosch Security Systems
Part III: Advanced Commands
CHANGE DISPLAY (COMMAND + 4 + 9)
Press to increase the LCD's
backlit brightness. The
backlight adjustment will take
effect after 20 seconds of
inactivity.
Press to decrease the LCD's backlit brightness. The backlight adjustment will
take effect after 20 seconds of inactivity.
D1260 Owner's Manual
50410C