Change Display - Bosch Security System Owner's Manual

Change Display

This function presents three options. One is to dim the display, one to brighten the display, and
one to continuously show the time and date in the display.
Bright/Dim
You can change your command center's display to make it bright or dim. When the display is dim,
the tones are softer than those when the display is bright. Use this option for command centers in
bedrooms where a brighter display and louder tones could interfere with sleep.
If you dim the command center display and an alarm or trouble condition arises, the display
automatically brightens and the volume increases. The display returns to dim lighting when you
clear the alarm or trouble condition.
Continuous Time/Date
Use this function to replace the disarmed idle text with a continuous time and date display.
Use this function to prevent passersby from knowing the status of your system.
Any time your command center has an event to display, the time and date display are
automatically removed. To return the time and date display, you must perform this function again.
1. Ensure that your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [4] key, followed by the [9] key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the CHG DISPLAY ? prompt. Press [ENT].
4. The display shows BRIGHT DISPLAY ?. Press [ENT] to brighten the display.
5. If you wish to dim the display or continuously show the date and time, press [NEXT].
6. The display shows DIM DISPLAY ?. Press [ENT] to dim the display.
7. If you wish to continuously show the time and date, press [NEXT]. Note: If your system
is turned on (armed), you cannot display the time.
8. TIME DISPLAY ? displays. Press [ENT] to continuously show the date and time.
9. Pressing [ESC] with the time and date showing returns the display to idle text.
49