License Plate Lamp - Chevrolet 2013 TRAX Owner's Manual

4. Remove the bulb socket from
the taillamp assembly by turning
it counterclockwise.
5. Remove the bulb by pulling it
straight out.
6. Install a new bulb into the bulb
socket.
7. Install the bulb socket into the
taillamp assembly by turning it
clockwise.
8. Install the taillamp assembly and
tighten the two screws.

License Plate Lamp

Lamp Assembly
Bulb Assembly
Vehicle Care
1. Bulb Socket
2. Bulb
3. Lamp Assembly
To replace one of these bulbs:
1. Push the left end of the lamp
assembly toward the right.
2. Turn the lamp assembly down to
remove it.
3. Turn the bulb socket (1)
counterclockwise to remove it
from the lamp assembly (3).
4. Pull the bulb (2) straight out of
the bulb socket (1).
5. Push the replacement bulb
straight into the bulb socket and
turn the bulb socket clockwise to
install it into the lamp assembly.
6. Turn the lamp assembly into the
lamp assembly opening
engaging the clip side first.
7. Push on the lamp side opposite
the clip until the lamp assembly
snaps into place.
10-31