Taillamps, Turn Signal, Sidemarker, Stoplamps, And Back-Up Lamps - Chevrolet 2013 TRAX Owner's Manual

10-30 Vehicle Care
Turn Signal Lamp
1. Open the hood. See Hood on
page 10 4.
2. Remove the turn signal lamp
bulb socket from the headlamp
assembly by turning
counterclockwise.
3. Remove the bulb from the bulb
socket by pulling it straight out.
4. Install the new bulb in the bulb
socket.
5. Install the bulb socket into the
headlamp assembly by turning
clockwise.
Taillamps, Turn Signal,
Sidemarker, Stoplamps,
and Back-Up Lamps
Passenger Side Shown, Driver
Side Similar
1. Sidemarker Lamp
2. Stoplamp/Taillamp
3. Taillamp
4. Back-up Lamp
5. Turn Signal Lamp
To replace one of these bulbs:
1. Open the trunk.
2. Remove the two screws, which
secure the taillamp assembly.
3. Remove the taillamp assembly
by pulling it straight back until
the two posts disengage from
the grommets. Do not pull on the
wiring harness.